What Size Motor For 12 Foot Aluminum Boat

Jika anda sedang mencari What Size Motor For 12 Foot Aluminum Boat, anda berada di tempat yang tepat! Disini saya akan mencoba membahas beberapa pertanyaan mengenai What Size Motor For 12 Foot Aluminum Boat.

How much horsepower do I need for a 12 foot boat?

Maximum horsepower is based upon the size of your boat, with the range being around 3-5hp for small 10-12 foot boats, all the way up to 60-75hp for longer 18-20 foot Jon Boats. You should follow your boat manufacturer’s suggested horsepower for the specific size of your boat.

What size motor should I put on a 12 foot jon boat?

12-foot jon boats have an average weight capacity of 420 pounds and an average maximum horsepower of about 5 to 7 HP, however, some models allow up to 10 HP. A 5 HP motor is expected to have a top speed of 10mph. 7 HP could have 15mph or more.

Can you put a 15 hp motor on a 12 foot jon boat?

A 15hp on a 12′ boat may porpoise, or (worse) cause the bow to dig in as the hull is sucked downwards from excess speed. (Yes, this happens). If you DO go with this size engine, avoid running it at WOT unless you have some extra weight in the boat.

How much hp does an aluminum boat need?

Aluminum Outboard-Powered Boats These boats can be powered by anything from 50-hp to 300-hp, depending on the size of the boat and the mission. Typically, these boats are used for fishing, so the size of the engine depends on the load to be carried and how fast the owner wants to go and how far.

How big of a boat will a 9.9 push?

To answer the question posted “Best size aluminum boat for 9.9hp 2-stroke?” A 12ft would provide the best performance with a 9.9. If you want more boat space then a 14ft would be better but would perform best with a larger motor.

What size motor should I put on my 14 foot aluminum boat?

It depends on the boat. Some 14’s are wide and deep and could handle a 25 while others are narrow and shallow and would be scary at any higher speed or even sitting still with all that weight. A 15 hp is a good compromise, same weight as a 9.9 and enough speed.

How wide is a 12-foot aluminum boat?

How wide is a 12-foot Jon boat? Around 48 to 60 inches on average.

Is a trolling motor enough for a jon boat?

Yes, a trolling motor is usually enough for powering a jon boat, but keep in mind that this requires using an adequately powered trolling motor for the size of your jon boat. If you choose an underpowered trolling motor (or run into strong headwinds), you may have problems moving the boat forward against the wind.

How fast will a 3.5 hp outboard go?

Question: How Fast will a 3.5HP Outboard Motor Go? Answer: A 3.5HP electric outboard motor can push a 12-foot boat with a load of 331 pounds at the most, with a speed of 5.6 MPH. It can sufficiently push forward a 10-foot tender and it can work for a day sailer as an auxiliary power for up to 3,307 pounds.

Can you troll with a 15hp outboard?

:twocents: Trolling with a 15 or a 40 is completely possible with a trolling plate. The key to using a plate is to make modifications that allow it to SUCCESSFULLY be used.

How much thrust does a 3hp Outboard have?

To give you a simple reference, a 3 hp electric outboard can push a 12 ft boat with 150 kg (331 lbs) load at a max speed of 9 km/h (5.6 mph). That’s to say the 3 hp outboard motor can provide more than sufficient propulsion for a 10 ft tender or work as an auxiliary power for a daysailer of up to 1.5 tonnes (3307 lbs).

What size outboard do I need?

The safest way to determine how much horsepower you need for your boat is to know the total weight of your boat. The rule of thumb is to have 25-40 pounds of weight per 1 horsepower. If your boat weight is 800 pounds you would need a 32-20 horsepower engine.

How fast will a 25hp outboard go?

A 25hp Pontoon boat will not be very fast, with an expected maximum speed of between 5 and 10 mph.

Can you put a bigger motor on a boat than its rated for?

If one were to put a larger than rated motor on the boat there would be pressure and stresses applied that may be over the acceptable range for the boat and serious damage could occur.

How fast will a 9.9 Yamaha outboard go?

Answer: Yamaha 9.9 HP features a top speed of around 20 MPH.

How fast will a 14 foot jon boat go?

14 Foot Jon Boat Speed You can expect 20-25mph out of your 14-footer. This boat length will generally allow for a 15-20hp engine, with some permitting up to 25hp motors.

How fast does a 9.9 Evinrude go?

The propeller is 9 1/4″ diameter x 8″ pitch. (Stock is 9 1/4″ x 10″) Top speed is 20 mph on the GPS.

How heavy is a 14ft aluminum boat?

Smaller aluminum fishing boats typically weigh around 400 pounds and a 14 feet cabin cruisers will often weigh around 14,000 pounds.

How heavy is a 12 foot aluminum boat?

12 Foot Jon Boat Weight: Average weight of 170 pounds (77kg) which is based on an average hull weight of 110 pounds (50kg) and average 6hp engine weight of 60 pounds (27kg). Sample Size: Alumacraft 12 Foot Jon Boat: 105 pounds (48kg)

Is a 12 foot jon boat big enough?

A 12-foot jon boat is perfect for teaching young anglers how to fish. You can access small unpressured waters, and because you’re sitting close to each other (unlike in a canoe), it’s easy to help them with gear problems — and take pics of a big fish before letting it go.

What size jon boat is most stable?

10 feet (3 m) long Jon boat This 50 inches (1.3 m) wide Jon boat is more stable and with a higher weight capacity than the smallest model on this list. It has two bench seats and can carry more loads.

How fast will a 55lb thrust trolling motor go?

Assuming perfect riding conditions, the use of the best fuel i.e. the distillate marine diesel, and moderate load, 55-pound trolling motors are likely to attain a maximum speed of only 5 miles per hour. This would take around two hours for the deep cycle battery charge to get completely depleted.

Who makes Mercury 3.5 hp outboard?

The engine is sold by Mercury Marine but manufactured by Tohatsu who also sells it under their brand and several others as well. The engine develops 3.5 Hp at 5,000 rpm, is a four stroke, single cylinder, and liquid cooled. The engine is carbureted and manual start and runs on regular 87 octane gas.

Does slow trolling hurt big engines?

Extended trolling at low speeds with this motor won’t hurt anything, other than maybe using a little more fuel than a small kicker would. If it was a 2 cycle motor with a Carburetor, then you waould have to worry about loading up after extended periods of idling. Keep trolling and don’t worry about it!

Terimakasih telah membaca What Size Motor For 12 Foot Aluminum Boat, semoga jawaban dari pertanyaan anda telah saya jawab semua. Semoga bermanfaat!